Fault code

BMW fault 4F92 - Ratio monitoring (clutch A-C)

P17F1 · Ratio monitoring

4F92 is logged by the EGS when it detects a gear ratio deviation involving both the forward clutch and the 2-6 brake simultaneously. These two elements are applied together in 2nd gear. This combined monitoring code points to issues with 2nd gear holding capacity.

The forward clutch and the 2-6 brake are applied together in 2nd gear. The EGS stores 4F92 when the ratio deviation implicates both elements. The emergency mode is 5th gear. This code commonly appears alongside 3-2 downshift ratio monitoring faults, typically triggered during engine braking in 2nd gear.

Safety warning

Repeated limp mode events indicate progressive internal damage, so have the vehicle towed rather than continuing to drive.

Module
EGS
Severity
Critical
Likely cause
Low or degraded transmission fluid
Common fix
Transmission fluid service and adaptation reset

Symptoms

  • Transmission malfunction warning on the instrument cluster or iDrive (CC-ID 420).
  • Transmission locks into 5th gear and will not shift.
  • Slipping or shuddering in 2nd gear under load.
  • Fault triggered when manually selecting 2nd gear during engine braking.
  • Intermittent limp mode during aggressive driving that clears on restart.

Common causes

  • Low or degraded transmission fluid reduces pressure in both the forward clutch and 2-6 brake circuits simultaneously.
  • Manually selecting 2nd gear at higher road speeds applies high reverse torque through both elements at once, which can trigger ratio monitoring even on transmissions with only moderate wear.
  • The 2-6 brake plates wear from high engine braking torque in 2nd gear.
  • Seal degradation causes systemic pressure loss to both circuits.
  • Wear in the support bushing that feeds the 2-6 brake circuit allows pressure crossleak.

Diagnosis

  1. Read the fault memory with a diagnostic tool. Check for companion 3-2 downshift ratio monitoring codes. The pair is a well-documented failure pattern. Note whether the fault was set during automatic operation or manual gear selection.
  2. Check the transmission fluid level and condition.
  3. Read clutch adaptation values. If both elements involved in 2nd gear are elevated, the pressure loss affects both circuits and the support bushing is suspect.
  4. Test both automatic 1-2 upshifts and manual 2nd gear selection during engine braking. If the fault only triggers during manual engine braking and not during normal shifts, the transmission is borderline and only fails under the torque reversal load.
  5. If the fault persists during normal automatic operation, a valve body overhaul with new solenoids and seals is the next step. If unresolved, transmission removal is needed for internal inspection.

Resolution

A fluid service and adaptation reset may resolve the fault if it only occurs during aggressive engine braking. If the code returns during normal automatic shifting, a valve body overhaul with new solenoids and seals addresses the hydraulic side. Internal clutch pack and support bushing replacement requires transmission removal.

Related fault codes

Last updated Jun 30, 2026 · Suggest an edit
ESC